I will share a sample drawing with right person
We'd like it edited for new specs:
thickness of material to be 1.5'
length 120'
width 23 7/8'
We would like channels routered in (the material is strong polyethylene
sheet).
Channels to be 3/4' deep, 1/2'-5/8 wide, set 5/8' apart. We would like
the channels to have a curve lengthwise similar to drawing (2' curve
over length I believe)
The ends of the channels to be tapered as shown, except have the tapers
meet up so that there is an arrow (or point) in the matieral NOT cut out.
____
The original drawing was for a 10.5' sheet, that wasn't as thick. We
want to use a thicker sheet, and wider to add a couple more channels
in. The channels are used to transport sheet materials in.
Please send me an approximate quote, and any questions you may have.
About the recuiterMember since Mar 14, 2020 Ikmi Inhil
from Ngwaketse, Botswana